Abstract
In this study, a pipelined noise-shaping successive-approximation register analog-to-dig-ital converter (PLNS-SAR ADC) structure was proposed to achieve high resolution and to be free from comparator design requirements. The inter-stage amplifier and integrator of the PLNS-SAR ADC were implemented through a ring amplifier with high gain and speed. The ring amplifier was designed to improve power efficiency and be tolerant to process–voltage–temperature (PVT) varia-tion, and uses a single loop common-mode feedback (CMFB) circuit. By processing residual signals with a single ring amplifier, power efficiency can be maximized, and a low-power system with 30% lower power consumption than that of a conventional PLNS-SAR ADC is implemented. With a high-gain ring amplifier, noise leakage is greatly suppressed, and a structure can be implemented that is tolerant of mismatches between the analog loop and digital correction filters. The measured signal to noise distortion ratio (SNDR) is 70 dB for a 5.15 MHz bandwidth (BW) at a 72 MS/s sampling rate (Fs) with an oversampling ratio (OSR) of 7, and the power consumption is 2.4 mW. The FoMS,SNDR (= SNDR + 10log10 BW/Power) is 163.5 dB. The proposed structure in this study can achieve high resolution and wide BW with good power efficiency, without a filter calibration pro-cess, through the use of a ring amplifier in the PLNS-SAR ADC.
| Original language | English |
|---|---|
| Article number | 1968 |
| Journal | Electronics (Switzerland) |
| Volume | 10 |
| Issue number | 16 |
| DOIs | |
| State | Published - 2 Aug 2021 |
Keywords
- Analog-to-digital converter
- Filter mismatch
- Noise-shaping
- Pipelined SAR ADC
- Pipelined noise-shap-ing SAR ADC
- Ring amplifier
Fingerprint
Dive into the research topics of 'Article a pipelined noise-shaping sar adc using ring amplifier'. Together they form a unique fingerprint.Cite this
- APA
- Author
- BIBTEX
- Harvard
- Standard
- RIS
- Vancouver